How to Protect Outdoor Furniture and Plants From Frost With Plastic Sheeting

How to Protect Outdoor Furniture and Plants From Frost With Plastic Sheeting

Last updated: November 2026

You drape plastic over your hydrangeas before bed, then wake up to black, mushy leaves. The worst damage is where the plastic touched the plant. A few weeks later, you uncover the patio furniture and find mildew on the cushions.

Plastic sheeting can help protect plants and outdoor furniture, but it needs to be used carefully. For plants, keep the plastic off the leaves and remove it promptly in the morning. For furniture, start with clean, dry pieces and make sure the cover sheds water without trapping damp air.

In brief: Place stakes or hoops around tender plants so the plastic forms a tent. Drape it to the ground and secure the edges before sunset. Uncover the plants the next morning once temperatures are above freezing. For furniture, remove cushions, create a sloped cover, and leave room for airflow.

Why Plastic Can Make Frost Damage Worse

Plastic sheeting is not insulation on its own. A thin sheet can become nearly as cold as the surrounding air. If it touches leaves, cold can transfer directly to the plant, and moisture trapped beneath the sheet may freeze against the foliage.

Much of the protection comes from warmth stored in the soil during the day. A cover that reaches the ground can help hold that warmth in the air around a plant. A frame keeps the plastic from touching leaves while allowing that pocket of air to form.

Colorado State University Extension reports that plastic placed over a frame can provide several degrees of frost protection, depending on conditions. The practical rule is simple: keep an air gap between the plastic and the plant, and secure the edges near the soil.

When Should You Cover Plants for Frost?

Consider covering frost-tender plants when the forecast calls for temperatures near or below 32°F. Pay attention when overnight lows are in the mid-30s, too: low-lying parts of a garden may become colder than the forecast suggests.

  • Light frost, around 29°F to 32°F: A well-secured cover on a frame may help protect tender plants.
  • Hard freeze, 28°F and below: Plastic alone may not provide enough protection. Move containers indoors if possible, protect roots with mulch, and consider adding a fabric layer beneath the plastic.

Clear, calm nights can be especially risky for plants. Check your local National Weather Service office for frost advisories and freeze warnings, and account for your garden’s conditions as well as the forecast.

What You’ll Need

  • Plastic sheeting large enough to reach the ground on every side
  • Stakes, tomato cages, or PVC or wire hoops to support the sheet
  • Bricks, rocks, sandbags, or landscape pins to secure the edges
  • Clamps or clothespins to attach the plastic to the frame
  • An old bedsheet or frost cloth for an additional layer on colder nights
  • Mulch, such as straw, shredded leaves, or wood chips

Thicker sheeting may stand up better to repeated handling and windy conditions, but check the product’s actual dimensions and thickness before buying to make sure it suits your project. Ecotez plastic sheeting can be considered for garden and household covering projects; confirm the listed specifications for the particular product before use.

Clear and opaque plastic can both be used for a short overnight cover. Clear plastic can heat up quickly in the morning sun, so remove it promptly. Opaque plastic blocks light, which is another reason not to leave it over plants during the day.

How to Cover Plants With Plastic for Frost

  1. Water the soil in the afternoon. Moist soil can store and release more heat than dry soil. Water the ground rather than the leaves.
  2. Build a frame. Place stakes around the plant, taller than its top growth. A tomato cage can work for an individual plant. For a bed, use hoops spaced along the row to support the sheet.
  3. Mulch around the base. A layer of straw or shredded leaves can help protect the root zone. Keep mulch clear of stems where appropriate.
  4. Cover before sunset. Put the plastic in place in late afternoon so the cover can help retain warmth released by the soil.
  5. Drape the sheet to the ground. Aim for coverage on every side, rather than leaving large openings where warm air can escape.
  6. Secure the edges and the frame. Use bricks, rocks, or landscape pins along the bottom, and clips to keep the sheet supported above the foliage.
  7. Uncover the plants in the morning. Once temperatures are above freezing, remove the plastic or open it up. Leaving a cover on can trap moisture, and sunny conditions can cause temperatures underneath to rise.
  8. Reuse the frame during a cold spell. Leaving the supports in place makes it quicker to cover the plants again when needed.

For colder conditions: Put a bedsheet or frost cloth over the frame first, then add plastic over the outside. The fabric provides another layer and helps keep the plastic from resting on foliage if it sags. Move potted plants into a sheltered indoor space when possible; container roots are more exposed to cold than roots in the ground.

Which Plants Need Covering?

Different plants tolerate cold differently. Use this as a general guide, and check the needs of the specific varieties in your garden.

  • Warm-season vegetables, such as tomatoes, peppers, squash, beans, cucumbers, and basil: Cover during a light frost. A hard freeze can cause severe damage, so harvest ripe produce and use additional protection where practical.
  • Cool-season vegetables, such as kale, spinach, cabbage, carrots, and lettuce: Many tolerate light frost, but a cover and root-zone mulch may help in a harder freeze.
  • Potted plants and tender ornamentals: Cover or move them to a sheltered spot during light frost. Bring them into a garage or indoors for a hard freeze when possible.
  • New plantings and seedlings: These are often more vulnerable than established plants. Cover them and consider an additional fabric layer and mulch.
  • Established shrubs suited to your area: They may not need routine covering, but unusual cold or a plant’s specific needs can change that.

The USDA Plant Hardiness Zone Map can help you identify your area, but a hardiness zone is only one part of deciding how to protect a particular plant.

How to Cover Outdoor Furniture for Winter With Plastic

Plastic can keep rain and snow off furniture, but it does not breathe like a fabric cover. Moisture trapped underneath can contribute to mold and mildew. The goal is to shed water while allowing damp air to escape.

  1. Clean the furniture and let it dry completely. Dirt and moisture trapped under a cover can contribute to mildew. Choose a dry day and allow pieces to dry before covering.
  2. Bring cushions indoors. Fabric can hold moisture and dry slowly under plastic. Store cushions somewhere dry.
  3. Create a tent. Use a stable support, such as an upside-down bucket or a stack of chairs on a table, to create a slope. A peaked cover sheds water better than a flat one and is less likely to rest directly on a tabletop.
  4. Leave room for airflow. Avoid sealing the furniture airtight. A small opening near the ground can help damp air escape.
  5. Secure the sheet. Use rope or bungee cords around the furniture so wind is less likely to lift the cover. Keep the top supported while leaving the bottom ventilated.
  6. Check after storms. Remove pooled water, brush off accumulated snow carefully, and lift the cover to air the furniture on a dry day when conditions allow.

Different materials have different needs. Natural wicker benefits from good airflow. Dry metal is less likely to develop rust spots under a cover. Plastic and resin pieces can become brittle in very cold conditions, so storing them in a shed or garage may be preferable if space allows.

When plastic may not be the best choice: If you plan to cover furniture for a long stretch without checking it, consider indoor storage or a fitted, breathable furniture cover. Plastic sheeting is more suitable when you can inspect the furniture and air it out periodically.

Common Mistakes to Avoid

  • Letting plastic rest directly on leaves instead of supporting it with a frame
  • Leaving clear plastic over plants during a sunny morning
  • Wrapping a plant in a plastic bag that presses against the foliage
  • Covering furniture while it is still wet from rain or dew
  • Wrapping furniture so tightly that damp air cannot escape
  • Leaving sheeting unsecured so wind can pull it loose

A frame, secure edges, timely removal, and airflow for furniture can make a big difference to how well a plastic cover works.

Frequently Asked Questions

Can you cover plants with plastic overnight?

Yes. Use a frame to keep the plastic off the leaves, extend the sheet to the ground, and secure it before sunset. Remove it the next morning once temperatures are above freezing, especially if the plastic is clear and the sun is out.

Should plastic touch plants during a frost?

No. Thin plastic can become very cold, and contact may transfer that cold directly to leaves. Use stakes, hoops, or a tomato cage to keep an air gap between the plant and the sheet.

What temperature should I cover my plants?

Cover frost-tender plants when the forecast approaches 32°F or lower. Garden conditions vary, so consider covering earlier if your yard has low spots or other areas that cool quickly. For temperatures around 28°F and below, add a fabric layer and mulch, or move pots indoors when possible.

Is clear or black plastic better for frost protection?

For a short overnight cover, the frame and trapped air matter more than the plastic’s color. Clear plastic can heat up quickly in morning sun. Opaque plastic blocks light. Remove either type during the day rather than leaving it over plants.

Can I leave plastic on plants all winter?

That is usually not a good approach for most plants. A cover can trap moisture and may heat up on sunny days. If you need ongoing protection for crops, use a suitable garden structure and open it for ventilation when conditions allow.

Is it okay to cover patio furniture with a plastic tarp?

It can be, provided the furniture is clean and dry, the cover slopes to shed water, and there is room for airflow. Secure the sheet against wind. For long periods without inspection, indoor storage or a breathable furniture cover may be a better choice.

Should I water plants before a frost?

Water the soil earlier in the day if it is dry. Moist soil can store and release more heat overnight than dry soil. Avoid wetting the foliage before temperatures drop.

Before Tonight’s Frost: A Quick Checklist

  • Check the overnight forecast and local frost or freeze alerts.
  • Water the soil around tender plants by mid-afternoon if it is dry.
  • Set up stakes or hoops so plastic will not touch the leaves.
  • Cover before sunset, extend the sheet to the ground, and secure the edges.
  • Bring potted plants and outdoor cushions into a sheltered, dry place.
  • Set a reminder to uncover plants the next morning.

Keep plastic sheeting and a few supports on hand so you can prepare when a cold snap is forecast. Before using any product, check its dimensions and specifications to confirm it is suitable for your garden bed or furniture.

Back to blog